The FireStik SS204 mount is specifically designed to allow antenna installations on vehicles where other mounts may not work. FireStik's primary goal was to offer a mount that could be affixed to a vertical inner door jamb such as that which might be found on the rear or side door of a cargo type van. Since the mounting screws are meant to be on the inner edge of the jamb, visible holes in the vehicle body are eliminated. Like many other FireStik mounts, the versatility of these mounts go well beyond their targeted use. When you hold this mount in your hand you will start to recognize all of the mounting possibilities. Chances are, you will find several locations to mount it on your vehicle. For antennas up to 4ft in length.
For further product information click on the product image (on the left) or the underlined product title (above).
The FireStik SS204A mount is specifically designed to allow antenna installations on vehicles where other mounts may not work. FireStik's primary goal was to offer a mount that could be affixed to a vertical inner door jamb such as that which might be found on the rear or side door of a cargo type van. Since the mounting screws are meant to be on the inner edge of the jamb, visible holes in the vehicle body are eliminated. Like many other FireStik mounts, the versatility of these mounts go well beyond their targeted use. When you hold this mount in your hand you will start to recognize all of the mounting possibilities. Chances are, you will find several locations to mount it on your vehicle. For antennas up to 4ft in length.
For further product information click on the product image (on the left) or the underlined product title (above).
The FireStik WTP4A mounting stud attaches to a chrome plated swivel bracket allowing the antenna angle to be adjusted perpendicular to the mounting plane. This allows the antenna angle to be corrected with the mount on the left or right edge of a trunk, hatchback or bumper. Hardware and mounting stud included.
For further product information click on the product image (on the left) or the underlined product title (above).
The FireStik WTP4A mounting stud attaches to a chrome plated swivel bracket allowing the antenna angle to be adjusted perpendicular to the mounting plane. This allows the antenna angle to be corrected with the mount on the left or right edge of a trunk, hatchback or bumper. Hardware and mounting stud included.
For further product information click on the product image (on the left) or the underlined product title (above).
The AUC10 Stainless Steel Hood / Trunk Lip Antenna Mount includes a lug type terminal stud which is designed to fit most pickup trucks that has a deep hood grove up to 3".
For further product information click on the product image (on the left) or the underlined product title (above).
This stainless steel under the hood antenna mount is designed for the 1995 to 2003 Dodge Ram pickups. Works also as an universal edge or lip antenna mount. Bracket has a 1/2 inch hole with lug stud terminal mount that is threaded for standard 3/8"-24 antennas.
For further product information click on the product image (on the left) or the underlined product title (above).
The AUVAN Stainless steel antenna mount is designed for vans with a slightly sloped hood, such as the Ford Econoline vans. Please note that if you are using with FireStik Fire-Ring coax cable remove the plastic isolation washer from the bottom half of the stud.
For further product information click on the product image (on the left) or the underlined product title (above).
Welcome to CB Radio Store 
